How do I reset EPB on Discovery 3?
With the Engine running, press the brake pedal fully on and off 3 times. On the third press, hold the brake pedal down. With the brake pedal still in the down position, pull the EPB switch upwards 4 times and then downwards 3 times. This must be completed within 10 seconds.
Where is the EPB switch located?
center console
The EPB switch is located in the center console. You can engage the EPB in two ways; Manually, by applying the park brake switch.
How do you release the park brake on a Discovery 3?
The parking brake can be released manually in the Discovery 3 and 4 by removing the small rectangular plastic cover situated just behind the parking brake lever and on the Range Rover Sport by unscrewing the 2 screws that hold the EPB lever in place, inside is a wire cable loop, pulling this will release the parking …
How do I turn off the emergency brake?
To turn off brake hold: Press the brake pedal and press the BRAKE HOLD button again. Automatic brake hold cancels when: Braking is applied for more than 10 minutes. The electric parking brake is engaged.
Why is my EPB light on?
EPB (Electric Parking Brake) Malfunction Indicator* The EPB (Electric Parking Brake) Malfunction Indicator illuminates when the ignition switch is turned to the ON position and will go out after a few seconds if the system is operating normally. If this happens this does not mean the EPB has malfunctioned.
How do I release my EPB manual?
With the AUTO switch OFF, the EPB can be applied by pushing and holding the parking brake switch. This will work with the ignition switch ON or OFF and with the vehicle moving or stationary. To release the brake, pull and hold the manual switch while at the same time pressing the brake pedal.
Where is the handbrake on a Range Rover Sport?
On Discovery 3 and 4 and Range Rover Sport 1 models the electronic park brake system comprises four main parts: the driver’s switch in the cab, the brake module mounted in the centre of the chassis infront of the spare wheel, the cables that run from the module to the wheel brakes to operate them, and the brakes …
How do you release an electronic handbrake with a flat battery?
If the battery dies, the parking brake system won’t operate. To release the parking brakes manually, a special tool is included along with the jack tools. Install the correct bit on the tool, remove the plug from the spare tire well, insert the tool and turn counterclockwise to release.