How do I service my Amana washer?
To run this cycle, place an affresh® Washer Cleaner tablet (or a cup of liquid chlorine bleach) in the bottom of your empty washer, and select the Clean Washer cycle. Press and hold the Start button to begin. After the Clean Washer cycle has stopped, run a Rinse & Spin cycle to rinse cleaner from washer.
Why is my Amana washer shaking violently?
Common solutions for: Amana Washer vibrating or shaking. One or more of the shock absorbers might be broken or worn out. The shock absorbers dampen the vibration of the washer tub. If one or more of the suspension rods are broken, the washer will vibrate or shake.
How do I fix my Amana washer that won’t spin?
Common solutions for: Amana Washer won’t spin or agitate. Inspect the drive belt to determine if it is broken or if it is loose on the pulleys. If the drive belt is broken or loose, replace it. The motor coupling connects the motor to the washer transmission.
Is there a reset button on Amana washer?
Press and hold the End of Cycle or Cycle Signal button for twenty seconds. This process also reset your Amana washer and clear the flashing light.
How long do Amana washers last?
7-10 years
This Amana washer can be found for as low as $300 on sale, which is about as cheap as it gets aside from Hotpoint washers (GE’s value line). Typically, washing machines (and most other major appliances) should last 7-10 years, but with a very cheap machine, it can be hard to know.
What is the warranty on an Amana washer?
For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, Amana brand of Whirlpool Corporation or Whirlpool Canada LP (hereafter “Amana”) will pay for factory specified parts and repair labor to correct defects in …
Why is my Amana washer making noise?
Common solutions for: Amana Washer is making loud noise. The tub bearing is mounted in the middle of the outer tub. The rear drum has a bearing or bearings in it to keep the inner tub spinning smoothly. If the tub bearing system is defective the washer can become very noisy.
How do I know if my washer suspension rod is bad?
The biggest sign of bad washer suspension rods is that your machine is vibrating or shaking more than usual, or more than it did upon purchase. In order to know for sure, you should look inside of the cabinet of your washing machine. Locate the washer suspension rods and assess any damage.
Why won’t my Amana washer go past the wash cycle?
Common solutions for: Amana Washer stops mid cycle If the door lock is defective, the washer may stop mid cycle. The door lock can fail either mechanically or electrically. Inspect the door lock for damage. If the door lock is damaged or does not latch properly, replace it.
Why is my Amana washer not working?
Make sure the power cord is plugged into a grounded three-prong outlet, not an extension cord. Then check your household circuit breaker, Ground Fault Circuit Interrupter (GFCI), and/or fuses to make sure they’re in good working order.
Why is my Amana washer not agitating?
Common solutions for: Amana Washer won’t agitate. If the washer won’t agitate, replacing the agitator repair kit may solve the problem. The kit contains the agitator components that are most likely to wear out and/or fail. If any of the parts are worn out, stripped, or damaged, replace the kit.
Why is my Amana washing machine leaking water?
Old or damaged supply hoses are a common cause of leaks located at the back of the machine. If you have a supply hose leak, the leak will continuously drip throughout the wash cycle. Here’s how to repair water supply hoses: Turn off the water main or shutoff valve.
Where are Amana appliances built?
Amana appliances are primarily and proudly made in the United States of America. The refrigerators are made in the town of Amana, Iowa. Dishwashers and other appliances are made in factories in Ohio while some ranges are made in Oklahoma.
Who makes Amana appliances?
The Amana Corporation is an American brand of household appliances. It was founded in 1934 by George Foerstner as The Electrical Equipment Co. in Middle Amana, Iowa, to manufacture commercial walk-in coolers. The business was later owned by the Amana Society and became known as Amana Refrigeration, Inc. It is now owned by the Whirlpool Corporation.