How do I turn off the service light on my Audi A4?

Start with the ignition turned OFF Press and hold the button on the right side of the display while turning the ignition on (position 2). Service OEL / OIL, should be displayed. Release the button on the right Pull out the button on the left side of the display until the service prompt is cleared.

How do I turn off the service light on my Audi?

Step 1 – Press “Trip Reset” button and start engine

  1. Pull the knob located on the right-hand side of the instrument cluster (trip reset button).
  2. Release the knob.
  3. Rotate the left-hand knob one full turn.
  4. Check the display for the following message, “Service In — Miles — Days — or Service!”
  5. Pull the knob once more.

How do you reset the service light on a 2001 Audi A4?

For 2000 to 2001 cars: Push in the odometer reset button (right button), hold it pressed, and turn the key to the first click. Step 3. In the display, “oil” or “service” or “insp” should now be shown.

How do you reset an Audi A4 computer?

Reset Audi ECU / Transmission

  1. Press the gas pedal to the floor.
  2. Turn on the ignition but do not start the engine.
  3. Keep the gas pedal pressed for at least 15 seconds.
  4. Turn off the ignition.
  5. Drive your Audi carefully and allow it to change gears at low RPM for the first 10 minutes.

How do you reset the service light on a Audi A4 B8?

AUDI A4 2015-2020 OIL CHANGE DUE RESET

  1. Start the Engine.
  2. Press the MENU BUTTON. ( number 4)
  3. Use the Number 1 button to navigate VEHICLE..
  4. Press Number 6 on INDIVIDUAL.
  5. Then select SERVICE CHECK.
  6. Then select SERVICE INTERVAL.
  7. Then Select RESET OIL CHANGE INTERVAL.
  8. then the confirmation message appear.

How do you fix the EPC light on a 2004 Audi A4?

You can reset the sensor with the following steps: Turn on the ignition switch. Slowly step on the gas pedal all the way to the floor. While holding the gas pedal on the floor, turn off the ignition switch.

How do you clear codes on Audi A4?

You can clear the codes in the ecu by disconnecting the neg. battery cable for a few minutes. Make sure you have the stereo code as you will need to input this. It takes roughly 40 miles for the ECU to reset and get back to normal after doing this.