How much does a split-face block cost?

Expect to pay about $3 per square foot for split-face concrete or cinder units and add $9 to $12 per square foot for installation labor, supplies, and equipment. A completed, 100-square-foot project will cost between $1,200 and $1,500, depending on the difficulty of the installation.

What is split-face concrete block?

Split-Face Block, Split-Faced Block & Rock-Faced Block all mean the same thing: A concrete building unit which appears to have been hand-chiseled (or “split”) to give it a very textured look. Sometimes architects refer to a Concrete Block as “CMU,” which stands for Concrete Masonry Unit.

How much do precast concrete blocks cost?

Precast Concrete Block Retaining Wall Costs

Type Cost Per Square Foot
CMU/Cinder Block $15 – $25
Concrete Block $15 – $30
Concrete Panel $30 – $60
Interlocking & Modular $15 – $50

How much does a 8x8x16 split-face block weight?

How much does a standard block weigh? Block weight will vary by size and configuration. A typical Medium Weight 8x8x16 weighs approximately 32 lbs per unit.

Can you paint split face block?

Split-face will typically require twice as much primer and paint than smooth block. The multiple coats of primer will help fill the porous split-face block. We typically use 100% acrylic coating as they outlast oil paints by a wide margin. A sprayer will likely be used to apply the coatings.

Is there a difference between concrete block and cinder block?

Concrete block is produced from steel, wood or cement. Cinder block is lighter than concrete blocks. Concrete block is heavier because it contains stone and sand. Cinder block does not have the strength to withstand high pressure.

What is the cheapest way to make a retaining wall?

The cheapest type of retaining wall is poured concrete. Prices start at $4.30 per square foot for poured concrete, $5.65 for interlocking concrete block, $6.15 for pressure-treated pine, and about $11 for stone. Installation or supplies, such as drainage stone or filter fabric, are not included.

How do you cover an exterior concrete block wall?

Surface bonding cement, used to build dry-stack block walls in place of mortar, can be used to create a smooth surface on concrete block. It’s a waterproof, flexible Portland cement reinforced with fiberglass. One of the benefits is that you can add color to the cement, eliminating the need to paint over it.

What is the best paint to use on concrete block?

Any high quality paint can be applied over Block Fill primer, but certain types perform better over time. The absolute best for exterior use is Elastomeric paint. This finish can outlast normal paint 2—1. The next best choice is 100% Acrylic semi-gloss or satin sheen paint.

How big is a Splitface concrete block?

Splitface concrete blocks are available a variety of both common and specialty concrete block sizes. Structural Units conform to ASTM C90, ACI 530, California Building Code (CBC) Chapter 21, and International Building Code (CBC) NOTE: Colors may vary compared to what is displayed on-line.

What are the requirements for a split face block?

Split Face 1 Conform to the requirements of A.S.T.M. C-90 (latest revision) Type 1 moisture controlled. (This is the standard… 2 Have a minimum face shell thickness of two (2) inches. 3 Are shipped shrink-wrapped and covered by plastic pallet covers. More

What are the requirements for custom concrete blocks?

Custom colors and shapes may be subject to: Minimum Order Quantity, Extended Wait Times, Mold Fees, and Agreement to purchase all units from the production run.