How much HP can a 383 stroker handle?
The 383 stroker engines have been reported to achieve 330 horsepower with 410 foot-pounds of Torque, 395 horsepower with 410 foot-pounds of Torque and 395 horsepower with 410 foot-pounds of Torque.
How much HP can you get out of a 355?
GM 355 Base Engine Cast Iron Vortec Heads Flat Tappet Cam 1pc RMS HP & Torque: 385 HP / 405 FT LBS – American Powertrain.
How much horsepower can you get from a Chevy 327?
375 hp
Rated at 375 hp, the fuel-injected 327 was a high-winding screamer, as satisfying to drive as any big-block. At the other end of the spectrum, the 327 was also offered at much more pedestrian power levels, as low as 210 hp (gross).
How much HP can a stock 350 block?
With a stock block, using after market crank, rods, pistons, bolts, heads, etc., you could expect a small block 350 to make upwards of 450 HP and for it to reliably handle upwards of 550 – 600 HP, and a big block with the same aftermarket components to make power in the 500 to 600 HP area, and be able to handle upwards …
How much HP can I get out of a 350?
a typical 350 Chevy can make upwards of 350 – 375 HP before you exceed the reliability of the components. For a big block with the same stock components it can make in the area of about 400 to 475 or so HP and handle upwards of about 500 HP before you exceed the reliability of the stock cast pistons.
What is 355 stroker?
Stroking an engine means to increase the stroke then in turn increasing the capacity of the engine. E.g. 308, install 355 stroker kit, increases the stroke and increases the capacity.
Which is better a 350 or 327?
The bottom line here is simple; no matter what you do to a 327, if you do the same thing to a 350, it WILL make more horsepower and torque than a 327 will, period. The same thing goes with ANY engine when comparing cubic inches and power, especially when you are talking about making more torque with longer strokes.
How much HP can a 396 make?
The average power numbers from 4,000 to 6,250 rpm (where it carried over 400 lb-ft of torque) were 438 hp and 450 lb-ft of torque. While power peaked at a high 6,400 rpm, low-end torque was still plenty respectable with the motor peaking 483 lb-ft at 4,700 rpm.