What is IOD fuse?
The ignition Off Draw (IOD) fuse is used to prevent battery discharge during shipping or long-term storage of the vehicle. The IOD fuse is located in the Total Integrated Power Module (TIPM). If the fuse is not completely inserted, partial contact of the fuse terminals could occur.
Where is the IOD fuse on a 2006 PT Cruiser?
Where Is the IOD Fuse Located?
| Vehicle | TIPM / IOD Fuse Location |
|---|---|
| Chrysler PT Cruiser (2001-2010) | engine compartment near the air cleaner assembly – a description of each fuse and component may be stamped on the inside of the cover |
| Dodge Grand Caravan (2005) | left side of the fuse box under the hood, near the battery |
How do I remove IOD main fuse?
When replacing the IOD fuse, you’ll want to pull up the casing until it won’t pull up anymore. Don’t force it. Then take a small screwdriver and pry open the top part of the casing. Once open, remove the fuse and replace it with a new one.
What does no fuse mean on a PT Cruiser?
Its your IOD fuse. If the odometer ever reads NO FUSE, your IOD is blown 85% of the time. It stops anything from drawing power off the battery, radio, power locks, etc.
Where is the fuse for the cigarette lighter in a PT Cruiser?
Cigar lighter (power outlet) fuses in the Chrysler PT Cruiser are the fuse №19 (2004-2005) or fuses №11 and 16 (2006-2010) in the Engine Compartment Fuse Box.
What is CCN fuse box?
the IOD fuse: • Cluster (CCN) • Diagnostic Connector.
What is the IOD fuse on a Dodge Ram?
This IOD or “Ignition Off Draw” fuse is used during assembly line work, and when vehicles are in storage on dealer lots to prevent battery going dead. It is recommended if vehicle sits unused for a period of time, say for more than 10 days or so, that you pull it to shut off parasitic drain to the battery.
What do you do when your car says no fuse?
Check the battery cables and make sure that they are tight and clean. Check the cables and wires on the starter and make sure that they are clean and tight. Check the fuse box for the starting main fuse and make sure that the fuse is not burned.
Why does my car say no fuse?
Check the battery cables and make sure that they are tight and clean. Check the cables and wires on the starter and make sure that they are clean and tight. Check the fuse box for the starting main fuse and make sure that the fuse is not burned. Any of these will cause the vehicle to not start.
Where is the fuse box on a Chrysler PT Cruiser?
There are two fuse boxes. One is the Integrated Power Module, which is the underhood fuse box.
When was the last Chrysler PT Cruiser made?
The last cruiser to have that was 2005. Everything is in the IPM (Integrated Power Module) that’s in the engine compartment. The whole electronic system was changed in 2006 to the CAN- BUS system which isn’t easy to work on. Do you have an owners manual?
Where is the power distribution center located on a PT Cruiser?
A Power Distribution Center (2001-2005) is located in the engine compartment; next to the air cleaner filter. A label identifying the components and circuits is located on the underside of the cover. An Integrated Power Module (2006-2010) is located in the engine compartment near the air cleaner assembly.
What kind of Fuse is the IoD fuse?
The IOD fuse is a standard 15 amp blade fuse; there’s a diagram on the inside of the IPM lid showing the fuse positions. The fuse pulls straight up and out – no tabs or anything to release to remove it – and reinserts the same way.