How can I make my car idle relearn?

To complete the idle relearn:

  1. Bring the engine to normal temperature, have the accessories off.
  2. Leave idling for 2 minutes in Park/Neutral to learn.
  3. With the vehicle securely held on the brakes or wheel chocks, change into Drive.
  4. Leave idling for 2 minutes in Drive to learn.
  5. Turn the Air-conditioning on full if fitted.

How do I reset idle control?

Turn the ignition ON and leave on for several seconds then turn the ignition OFF to allow the ECM to reset the IAC valve. You should be good to go.

Why do idle relearn?

Many newer cars with powertrain control modules (PCMs) have to relearn engine idle after a battery is disconnected. The removal of electrical power from the engine erases idle memory from the PCM, the computer where it is stored.

What RPM should my Corolla idle at?

Typically, the idle speed will be set at a value in the range of 600 to 800 RPM, but the exact value will depend on the number of engine cylinders and whether the vehicle is equipped with a manual or automatic transmission.

What are symptoms of a bad idle control valve?

Common signs include irregular or unusually high idle speed, the Check Engine Light coming on, and stalling while idling.

How long does it take for an ECU to relearn?

When resetting the ECU it will take about 50km (31 miles) to relearn.

How to reset the idle speed on a Toyota?

For some reason toyota in all there wisdom do not store the idle parameters permanently in the ECU so here is the correct way to reset the idle speed 1. warm the engine up, make sure all accessories fans lights etc are off 2. turn the ignition fully on and fully off twice in succession

How to trigger an idle throttle position re-learn?

The car had rough idling, even engine stalled. So removed the throttle body and cleaned it up. After fixing back the throttle, the idle rpm went up to 2200! Kept the engine idling for more than 10 minutes, removed battery negative twice, but no change! Then took the car for a test ride.

What should I do if my car won’t idle?

Step 8: Press the accelerator pedal to the floor and count for 10 seconds and then release the pedal for 10 seconds. Do this 2 times Step 9: Quickly press the accelerator pedal to the floor and then release three times. Step 10: Start the engine. If it does not idle correctly after this procedure, you will need to clean the throttle body.

Is there a throttle relearn procedure on a CTS?

It is a fly-by-wire system so it is basically a fancy servo motor on a RC-Car. The owners manual had no mention about a throttle relearn procedure. My Cadillac CTS has a procedure in the owners guide but it varies from Make to Make.

By Questions and answers